Thingiverse
Face Mask Filter
by winegar21
11
Downloads
19
Likes
0
Makes
The original idea in designing this was to create a face mask that could be reusable and use the least amount of N95 fabric(a special fabric used in traditional face masks to disinfect). As of now hospitals are running low on medical supplies and I am sure donations to them would be greatly appreciated.
Materials required
Printed parts found here on page includes 2-3 depending on the face mask
1 ¼ “ N95 fabric. As a side note you can cut up a traditional face mask to preserve its longevity.
A hand made face mask. Tons of patterns for N95 fabric ones exist however with this filter masks can be made out of traditional fabric.
Scissors or preferably an Exacto knife.(to cut out hole in sewn mask for filter)
Assembly steps
After making a sewn mask cut out 1 ¼” hole in front for filter
Next cut out a 1 ¼”- 1 ½” inch piece of N95 fabric
Place top of the filter into pre cut hole in mask
After completing the above steps carefully place N95 fabric centered on filter’s cylinder
Materials required
Printed parts found here on page includes 2-3 depending on the face mask
1 ¼ “ N95 fabric. As a side note you can cut up a traditional face mask to preserve its longevity.
A hand made face mask. Tons of patterns for N95 fabric ones exist however with this filter masks can be made out of traditional fabric.
Scissors or preferably an Exacto knife.(to cut out hole in sewn mask for filter)
Assembly steps
After making a sewn mask cut out 1 ¼” hole in front for filter
Next cut out a 1 ¼”- 1 ½” inch piece of N95 fabric
Place top of the filter into pre cut hole in mask
After completing the above steps carefully place N95 fabric centered on filter’s cylinder
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
