Thingiverse
Face Shield
door jhpiedrahitao
21
Downloads
11
Likes
0
Makes
License
Millenium BPO S.A. Bogotá Colombia
CC BY-NC-SA
This license lets others remix, adapt, and build upon your work non-commercially, as long as they credit you and license their new creations under the identical terms.
Printing parameters for “mascara proteccion V2”
FDM
Material PLA:
Layer Height: 0.3mm
Nozzle Diameter 0.4mm
Infill 100%
Printing temperature: 210°
Build plate temperature 60°
Printing speed 70mm/s
Support material NO
Printing parameters for “broche mascara V2”
FDM
Material PLA:
Layer Height: 0.15mm
Nozzle Diameter 0.4mm
Infill 100%
Printing temperature: 210°
Build plate temperature 60°
Printing speed 70mm/s
Support material NO
Disclaimer:
This Face shield is for personal use and is NOT a substitute for wearing face masks, gloves, or not following the safety protocols notified by health authorities for the prevention of Covid-19 infection.
Esta máscara es de uso personal y NO reemplaza el uso de tapabocas, guantes, ni el segui
Millenium BPO S.A. Bogotá Colombia
CC BY-NC-SA
This license lets others remix, adapt, and build upon your work non-commercially, as long as they credit you and license their new creations under the identical terms.
Printing parameters for “mascara proteccion V2”
FDM
Material PLA:
Layer Height: 0.3mm
Nozzle Diameter 0.4mm
Infill 100%
Printing temperature: 210°
Build plate temperature 60°
Printing speed 70mm/s
Support material NO
Printing parameters for “broche mascara V2”
FDM
Material PLA:
Layer Height: 0.15mm
Nozzle Diameter 0.4mm
Infill 100%
Printing temperature: 210°
Build plate temperature 60°
Printing speed 70mm/s
Support material NO
Disclaimer:
This Face shield is for personal use and is NOT a substitute for wearing face masks, gloves, or not following the safety protocols notified by health authorities for the prevention of Covid-19 infection.
Esta máscara es de uso personal y NO reemplaza el uso de tapabocas, guantes, ni el segui
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
