Thingiverse
Face Shield
von 3D-Designs
17
Downloads
19
Likes
0
Makes
Face Shield
Very little parts are required for the finished part.
Parts used:
A4 PPC Film Clear 100-Micron or Binding Comb Covers 250-Micron
Paper Hole Punch.
Hole centres.
80mm between the corner fixings to the centre
and 60mm between the 2 centre fixings
The fixings have a small slot for the Film to sit in, and two side lugs to keep them in place.
This is a modification on parts already being printed for the COVID-19 outbreak.
Very little parts are required for the finished part.
Parts used:
A4 PPC Film Clear 100-Micron or Binding Comb Covers 250-Micron
Paper Hole Punch.
Hole centres.
80mm between the corner fixings to the centre
and 60mm between the 2 centre fixings
The fixings have a small slot for the Film to sit in, and two side lugs to keep them in place.
This is a modification on parts already being printed for the COVID-19 outbreak.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!