Fall

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #6 (0.56mm) swap to RedAt layer #20 (1.68mm) swap to OrangeAt layer #22 (1.84mm) swap to YellowAt layer #25 (2.08mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!