FDL-3 Narfduino and OLED screen Mod

Included are the files I needed to modify to get my FDL-3 to work.

The Screen Housing will fit a small OLED screen.
The electronics housing was modified to fit a narfduino. Also included a round cutout so you can leave the narfduino plugged in while the blaster is assembled (minus the stock mounting point)
My printer prints holes too tight so I included an expanded magwell so my mags would gravity drop
The mag switches are a little longer than those included in the airzone files
My motors weren't lined up exactly so I redesigned the motor mount plates with a small recess to get the wheels to line up. Also included a shim in case that is too low and you need to raise it back up a bit.
ESC cap was chopped down to fit my electronics