Thingiverse
Fender Tuner Nut Drill Guide
von taqTokToe
0
Downloads
0
Likes
0
Makes
Made for accurate drilling / spacing of the tuner holes on telecaster style headstock when using Wilkinson JN05LLocking tuners. 10mm dia x 24.5mm spacing.
You will need the jig and 2x locator pegs
Position using the lip on the jig, drill one of you E tuners, push in a locator peg, drill the other E tuner, push in the second locator peg. Now drill the other holes.
I made the jig quite thick as i wanted it to act as a bit of a drill guide too.
Its a one shot tool at the moment as the 10mm holes are a tight fit but worked a treat.
You will need the jig and 2x locator pegs
Position using the lip on the jig, drill one of you E tuners, push in a locator peg, drill the other E tuner, push in the second locator peg. Now drill the other holes.
I made the jig quite thick as i wanted it to act as a bit of a drill guide too.
Its a one shot tool at the moment as the 10mm holes are a tight fit but worked a treat.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
