Slicer Discord
Fiber Lamp - WLED – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Fiber Lamp - WLED

477 Downloads
722 Likes
182 Makes
Zum Modell
Hi Maker,Here an easy DIY for building a Fiber Lamp using WLED. Based on an original idea of andrei.erdei, but completely redesigned (bigger with 36 leds, improved, simpler with WLED)This fiber lamp is controlled exclusively in WIFI via the WLED interface (power on/off, choice of effects, etc.) BOM5 meter of fiber (diam 3mm) (https://fr.aliexpress.com/item/1005002987759286.html)1x ESP32 WROOM1x USB C (https://fr.aliexpress.com/item/1005007148475800.html)1 meter of ws2812b (36 leds) 60 leds / meter, IP305v 2/3A usb poweroptional ESP32 case (print this : https://makerworld.com/en/models/186291 )some wire (24 - 20 AWG)4 x M3-16 (to attach the frame to the base) or glue (not recommanded)4 x M3-16 (to attach the lid under the base)4 x M3 - 6 (to close the frame with the lid frame) or glue Instructionprint the elementsPrepare the ESP32 by installing WLED (directly from the WLED site https://kno.wled.ge/ ; https://install.wled.me/ )cut 4 strips of 9 LEDs, solder them with about 5cm of wire (2
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
großer Druck · aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 2/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
200 mm (Groß)
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen