WLED Desk Tower Light

Fully 3D Printable RGB Tower Light, 40 cm high, using WLED controller. Inspired on multiple design arround, but designed from scratch.UPDATE:Cover V2.stl has some more clearance around the tower2 USB C connectors are used to daisy chain another light, .since it 1 light at max power only draws 1.5A a 3A power brick can be used to power 2 lights. Electronic parts needed:Wemos d1 mini (or other wled compatible controller)USB C adapter boards (2x)WS2812B LED strip (24leds) (10mm wide)USB C Power brickConnecting is fairly easy connect the 5V from USB C boards, Wemos and LED Strip and do the same for the GND.Make sure the data wire from Wemos (defaults to D4) is as short as possible otherwise a level convertor will be needed.Use some glue to connect the top tower to the base. Be carefull mounting the diffusors since they are pretty thin, it is a little bit fragille, but making them thicker is going to block to much light. I used PLA, no supports are needed. Inspiration source:https://www.pri