Fidget Button

This is a remix of EG3Dprinting's fidget toggle switch. Instead if switching, it's a button press that springs back out.

Forgive the crudeness of the remix, I'm new to all this. I just wanted to make a button for my son and felt I should share it.

This version uses two 6mm x 2mm neodymium magnets. The magnets need to repel one another and I had to glue one magnet in before fitting the other else it would be too fiddly.

You may need a support for the recess under the button top, but aside from that I just used standard print settings. 15% infill etc.