Thingiverse
Fidget Spinner - Hoverboard / swagway
di reverman
21
Download
15
Likes
1
Makes
Things needed:
Board (qty 1) - either board will work the revised board is a little longer and has a snugger fit on the axle
Axle (qty 2)
608 bearings (qty 3)
Rev 2: I tightened up the center bearing hole clearance. The bearing fit gets a bit loose after breaking it in. will make it a bit more difficult to assemblebut overtime I think it will last longer.
- Made 1 Tri version you'll need another bearing and 1 more axle
- Designed a skateboard version: http://www.thingiverse.com/thing:2310966
added thumb pads
-revised axel to make abit shorter and made bearing fit a little looser some bearings were very tight fits
Board (qty 1) - either board will work the revised board is a little longer and has a snugger fit on the axle
Axle (qty 2)
608 bearings (qty 3)
Rev 2: I tightened up the center bearing hole clearance. The bearing fit gets a bit loose after breaking it in. will make it a bit more difficult to assemblebut overtime I think it will last longer.
- Made 1 Tri version you'll need another bearing and 1 more axle
- Designed a skateboard version: http://www.thingiverse.com/thing:2310966
added thumb pads
-revised axel to make abit shorter and made bearing fit a little looser some bearings were very tight fits
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
