Thingiverse
Fidget spinner
by mads91
7
Downloads
3
Likes
0
Makes
Made a fidget spinner with washers and bolts as weight, instead of bearings. This way will save you the use of 3 bearings.
The bolts are M4x8 mm, and the nut is a square M4.
The washers are Ø18 mm.
Bearing: ABEC-7 608 rs, all 608 bearings should fit.
Print setup:
Material: Innofill PLA silver (all "hard" materials should be fine)
Heat nozzle: First layer; 205 C , afterwards 200 C
Heat bed: non
Nozzle size: 0,3
Layer height: 0,15
Support under each "washer space", if your printer is good at bridging it should be possible without support.
The bolts are M4x8 mm, and the nut is a square M4.
The washers are Ø18 mm.
Bearing: ABEC-7 608 rs, all 608 bearings should fit.
Print setup:
Material: Innofill PLA silver (all "hard" materials should be fine)
Heat nozzle: First layer; 205 C , afterwards 200 C
Heat bed: non
Nozzle size: 0,3
Layer height: 0,15
Support under each "washer space", if your printer is good at bridging it should be possible without support.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
