Thingiverse
Fidget spinner
di mads91
7
Download
3
Likes
0
Makes
Made a fidget spinner with washers and bolts as weight, instead of bearings. This way will save you the use of 3 bearings.
The bolts are M4x8 mm, and the nut is a square M4.
The washers are Ø18 mm.
Bearing: ABEC-7 608 rs, all 608 bearings should fit.
Print setup:
Material: Innofill PLA silver (all "hard" materials should be fine)
Heat nozzle: First layer; 205 C , afterwards 200 C
Heat bed: non
Nozzle size: 0,3
Layer height: 0,15
Support under each "washer space", if your printer is good at bridging it should be possible without support.
The bolts are M4x8 mm, and the nut is a square M4.
The washers are Ø18 mm.
Bearing: ABEC-7 608 rs, all 608 bearings should fit.
Print setup:
Material: Innofill PLA silver (all "hard" materials should be fine)
Heat nozzle: First layer; 205 C , afterwards 200 C
Heat bed: non
Nozzle size: 0,3
Layer height: 0,15
Support under each "washer space", if your printer is good at bridging it should be possible without support.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
