Thingiverse
Filament Wall Bracket
von GdJ
15
Downloads
11
Likes
0
Makes
I created this filament wall bracket to hold at least 10 reels against my wall as I change colour quite a lot.
I used a 22mm copper pipe as a shaft, you can use anything up to 25mm.
I used a 22mm copper pipe as a shaft, you can use anything up to 25mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!