Thingiverse
Filing Jig - Includes Gridfinity version!
von Grandwigg
0
Downloads
1
Likes
0
Makes
Filing Jig For Needle Files and Full Size
When using my needle files post processing some of my 3D prints, I realized I wanted a way to be more consistent with the angles in play. A few quick measurements and a silly bit of time on Tinkercad later, sucess!
A 45 degree and 90 degree angle for both the needle file(3mm/.12inch) and full-size file (15mm/.9inch).
It's not fancy, but it was a good starting point at least for me. I hope it is at least a little helpful for someone else.
The version compatible with Gridfinity was made simply by using the slicer's “Add Part” menu option to add and line up a blank 3x3 bin from the Gridfinity Refined collection. ( https://www.printables.com/model/413761-gridfinity-refined )
I printed mine in Grey Elegoo PLA,
I used Gyroid infill at 15% with 2 walls and 0.2 layer height, basic settings.
No supports are used on my Elegoo Centauri Carbon for the Gridfinity ver.
It fits all of my needle files except one that is a much wider half-mo
When using my needle files post processing some of my 3D prints, I realized I wanted a way to be more consistent with the angles in play. A few quick measurements and a silly bit of time on Tinkercad later, sucess!
A 45 degree and 90 degree angle for both the needle file(3mm/.12inch) and full-size file (15mm/.9inch).
It's not fancy, but it was a good starting point at least for me. I hope it is at least a little helpful for someone else.
The version compatible with Gridfinity was made simply by using the slicer's “Add Part” menu option to add and line up a blank 3x3 bin from the Gridfinity Refined collection. ( https://www.printables.com/model/413761-gridfinity-refined )
I printed mine in Grey Elegoo PLA,
I used Gyroid infill at 15% with 2 walls and 0.2 layer height, basic settings.
No supports are used on my Elegoo Centauri Carbon for the Gridfinity ver.
It fits all of my needle files except one that is a much wider half-mo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
