Thingiverse
Firefly Longboard Remote Controller , split for tiny printers
von buZztiaan
3
Downloads
6
Likes
0
Makes
I wanted to print the firefly controller, but my printer is too small.
Also , i used the 128x64 oled cause i had many of them around.
UPDATE; added a alternate split for the bottom side, so the split doesnt align on both halves (oops)
Also , i used the 128x64 oled cause i had many of them around.
UPDATE; added a alternate split for the bottom side, so the split doesnt align on both halves (oops)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!