Fish Filter Diffuser
von M3ch4tr0n1cs
6
Downloads
4
Likes
0
Makes
Apologies to all the hardcore aquarium people for calling this a "Fish Thingy". I made it for my sister and am not an aquarium owner myself.
This is a diffuser to prevent a high fluid flow rate filter from pushing fish. After doing long term testing with PLA in water, I found little to no degradation, though PETG might be a safer alternative. Because of this and the fact that PLA is food safe, I believe that it will not harm the fish. This model is far from perfect, but some people asked for me to post it. If anyone wants to improve it, here are some changes I would make:
1. Make the holes increase in diameter from the filter.
2. Tweak the clip geometry (the filter this was designed for had mostly curved surfaces which made tight-fitting geometry difficult to achieve).
This is a diffuser to prevent a high fluid flow rate filter from pushing fish. After doing long term testing with PLA in water, I found little to no degradation, though PETG might be a safer alternative. Because of this and the fact that PLA is food safe, I believe that it will not harm the fish. This model is far from perfect, but some people asked for me to post it. If anyone wants to improve it, here are some changes I would make:
1. Make the holes increase in diameter from the filter.
2. Tweak the clip geometry (the filter this was designed for had mostly curved surfaces which made tight-fitting geometry difficult to achieve).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
