Flashforge Creator Pro Bed Level code

Included with the Flashforge Creator Pro is "Plate_levelling.x3g" - I didn't like that this script doesn't actually position the extruder nozzle over the bed adjusters, and of course you can't edit it as its x3g. I run off an SD card, so using something like RepG/S3D etc to assist in the level was not for me.

I wrote this script as I wanted more control over the bed level cycle.

Both the x3g and the source g-code file are included. If you want to customize the leveling positions, just edit them in the g-code, and compile into x3g with ReplicatorG.

*Note*
1.This cycle is setup for touching off the nozzle on a standard .100mm thick piece of paper. If you use this with the included blue Flashforge sheet (.200mm thick) it will be wrong!
2.The attached calibration cube is just here because Thingiverse won't let me just upload code.