FlashForge Creator Pro - Lid brackets

I have the generation before the 2016 FF c pro and the guy didn't give me the lid with it. So I had to buy the only lid FlashForge provides, which is the unibody lid for the 2016 creator pro. Well, if you don't know, it is 12mm too short to sit on the top and there are no brackets to hold it down. So here it is, I am still working on it and adding some features for the bracket to make it better. But in the meantime, it fits snug and it holds down.

UPDATE:

I did an update on the bracket. It isn't in its final stages yet, but it does look better. It seats really nice now due to the tabs on the lid holding it down. I also reduced the plastic by a good margin and the time went down from 18mins to 13mins. No supports really needed.


UPDATE 5/24/2020:

clip v2.3 is released. I have updated a top part of the clip where you can mount it from above or below. I will be testing this print when I get the time. Prints will be done in TPU and PETG. Flip the object over on th