Flashforge z axis end stop trigger

Used a set of old ender3 yellow springs i had laying around which made the nozzle too close I initially was just adjusting my z offset in the profiles but then i decided to get the flexible build plate from the creator pro which was even thicker.. I saw some files on here that used spacers but i thought just replacing the arm that triggers the z stop would be quicker and easier. I made it adjustable where the lowest setting should be stock and then it can move up 3 mm.. uploaded the Step so you can change it if you're using a glass bed or something thicker then that :)

should allow for easier swap options imo and if you want you could have a bit of wiggle room in case you wanted to put on a different print surface on for some print and swap back and forth just adjust the arm in the slot re level and go.

this may be able to used in other flashforge printers as well as the dremel ideamaker and some monoprice printers