Thingiverse
Flashlight diffuser
von dude2k5
18
Downloads
6
Likes
0
Makes
Just some flashlight diffusers. Printed with PLA and it didnt seem to melt. Has a small hole on top so it wont overheat.
Works with the BLF Q8, Sofirn SP36 BLF, and Emisar D4v1, not sure v2 works but it may if it's the same diameter.
Works with the BLF Q8, Sofirn SP36 BLF, and Emisar D4v1, not sure v2 works but it may if it's the same diameter.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
