Thingiverse
Flight Controller Base
von AllisterS
7
Downloads
5
Likes
0
Makes
Looking for a sick new mount for your slammed 5" freestyle rig? Then keep moving because this ain't it.
This is a 30x30 mount to fit a Matek F405-STD board and PDB. But I'm sure any 30x30 FC would fit. I printed it in TPU to help with vibration damping. Time will tell if that was a good idea or not. There's nothing particularly unique about this, it was mostly just to fit the hardware and placement I wanted. And if the TPU snot on the print was enough of a clue, I'm new to printing with TPU so I figured this was just as good a reason as any to try.
This is a 30x30 mount to fit a Matek F405-STD board and PDB. But I'm sure any 30x30 FC would fit. I printed it in TPU to help with vibration damping. Time will tell if that was a good idea or not. There's nothing particularly unique about this, it was mostly just to fit the hardware and placement I wanted. And if the TPU snot on the print was enough of a clue, I'm new to printing with TPU so I figured this was just as good a reason as any to try.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
