Thingiverse
Flirc Raspberry Pi Zero Case Back
von ZettaPixel
8
Downloads
5
Likes
1
Makes
When I ordered a RPi zero 2 w as my Octoprint board, I received a Flirc Raspberry Pi Zero Case with it. The case is intended as a heat sink, w/ a screw on plastic back. This print allows for the case to slide into a slot on the extruded aluminum, allowing for multiple mounting locations.
The print is offset so it would sit lower on the foot of my Ender3 printer, and allow for the connections to be located at the top.
The print is offset so it would sit lower on the foot of my Ender3 printer, and allow for the connections to be located at the top.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!