Slicer Discord
Float Bracket – 3D printable model from Thingiverse Thingiverse

Float Bracket

1 Downloads
1 Likes
0 Makes
Go to Model
This bracket mounts on a 1/2 inch PVC pipe. The floats are from Amazon look for "smraza" or www.smraza.com.
I am using this set up to monitor a 10.000 l water cistern I have 4 floats for each 2500l. Control's can be an Arduino or a basic 4 LEDs setup. The floats can be inverted if you need always on / or always off. The M4 screw is delicate so no over tightening be carful but this way noting can rust. I use Cat5 cable
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection