Thingiverse
Ford Focus trunk shelf support knobs
von Tarasus
4
Downloads
8
Likes
0
Makes
A simple knob for Ford Focus trunk shelf (sometimes called "privacy cover") with ability to pull 2-3mm paracord through hole, instead of balljoint-like interface.
Make sure to orient the model in your slicer, so the through-hole is perpendicular to the build plate. This gives it the most strength, and it's easier to pull the cord through.
Requires supports for the knob part.
Also use 100% infill or max walls count for it to be as solid as it could be.
No print result photos because the thing is already in use.
Make sure to orient the model in your slicer, so the through-hole is perpendicular to the build plate. This gives it the most strength, and it's easier to pull the cord through.
Requires supports for the knob part.
Also use 100% infill or max walls count for it to be as solid as it could be.
No print result photos because the thing is already in use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
