Thingiverse
fox float dps tools
von uproar
1
Downloads
1
Likes
0
Makes
A couple of hard to find in NZ tools for rebuilding a 2019 fox float evol dps rear shock.
No support needed for the socket, I used (around) 1.5mm stainless tig rod for the pins and glued them in. 1/4' drive.
The lift plate tester uses a dial meter with a 8mm/40mm shaft and is held in with a m3 bolt.
No support needed for the socket, I used (around) 1.5mm stainless tig rod for the pins and glued them in. 1/4' drive.
The lift plate tester uses a dial meter with a 8mm/40mm shaft and is held in with a m3 bolt.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!