FPV-Cube-Corner

with Fusion360 I created two versions of corners, to build a cube or gates. The first is only for 20mm installation tubes(Tiny Whoop). See the picture. The second is combined 20mm/25mm. The second is better for taller Cubes, so you can put the 20mm tubes into the 25mm one, for transportation to save space in the car. I printed PLA with 20% infill and standing position and no support. The downside stiffening bridges are a little bit tricky, but you will get it. I have not tested the tall gate, but I think it would work.
Have fun with the cube.