Frontrunner Wolf Pack Block

This is a block that will go on a Frontrunner tray and allow you to "mount" a Frontrunner Wolf Pack. The block will go into the corner space that is open from underneath. This works with the regular Wolf Pack, not sure about the "Pro" version.

**Hardware needed** is a 5/16 x 1" bolt and matching nut. Could use 1-1/4 or 1-1/2, 1" is going to be the minimum. The nut goes in the recess and the bolt goes in the track. If you cannot get the block in the orientation you need try backing it off enough to slide it out, rotate the whole thing outside the track about a quarter turn in the direction you need, then try again.

Two of these will hold 1 Wolf Pack very securely, you need one strap and two eyes to hold it down as opposed to 2 and 4. You can mirror the object in your slicer to get the opposite side.