Fuse Bridge

This is the fuse bridge that German pioniers would use to connect the timed fuse with the friction igniter.

- How it works is to take your fuse (I use 4mm black paracord for reenacting) and feed it through the open hole of the pronged piece.
- Next, thread your ANZ 29 or ANZ 39 onto the large end of the bridge.
- Feed your fuse inside the bridge until it cannot go any further.
- Thread the pronged piece inside the bridge until it cannot tighten any further.
The prongs will tighten onto the fuse and prevent it from moving or slipping.

NOTE: the prongs may need to be pressed in a bit after printing so they will not get caught on the inner wall the first time threading.