G-Shock Table Clock Conversion

Table Clock conversion for a G-Shock G-9100.

You have to remove the shell first, then remove the pushers by opening the case, use 1-1,5mm rods as substitute for pushers, then add Meccano hex screws and square nuts as top pushers, regulating the travel by tightening the screws until there is about 0,2 mm free space.

Opening and removing the movement is needed and fundamental for correct installation, this mod will make the watch NOT water resistant anymore, so if you plan on submerging your house don't install this mod. Cheers.

You can buy me a beer at https://paypal.me/decadenzio