Thingiverse
Gan Craft 5.5
von AAEM
2
Downloads
3
Likes
0
Makes
Some time ago, someone asked for this particular lure but it was 2.75" long. I wanted a little larger so i made it 5.5" in addition to the 2.75".
Lure volume:
Head: 34.45 g/cm3
Tail: 14.43 g/cm3
Slice your lure accordingly. If you want the lure to float, total weight including every single hardware need to be less than the volume above. It's best to calculate them separately if you can. There's a cavity inside the lure in the front for adding a rattle weight.
Youtube shorts: https://youtube.com/shorts/H-MDQ7wGvaQ?feature=share
Info from YouTube shorts:
Music is by Rob Coleman of #7PotClub here on YT.
7PotClub: https://www.youtube.com/ @7PotClub
Rob's other channel: Hubcap Club:
https://www.youtube.com/ @HubcapClub
Lure volume:
Head: 34.45 g/cm3
Tail: 14.43 g/cm3
Slice your lure accordingly. If you want the lure to float, total weight including every single hardware need to be less than the volume above. It's best to calculate them separately if you can. There's a cavity inside the lure in the front for adding a rattle weight.
Youtube shorts: https://youtube.com/shorts/H-MDQ7wGvaQ?feature=share
Info from YouTube shorts:
Music is by Rob Coleman of #7PotClub here on YT.
7PotClub: https://www.youtube.com/ @7PotClub
Rob's other channel: Hubcap Club:
https://www.youtube.com/ @HubcapClub
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
