Slicer Discord
Garden Scarecrow – Modèle 3D imprimable de MakerWorld MakerWorld
Gadgets

Garden Scarecrow

5 Téléchargements
6 Likes
2 Makes
Voir le modèle
Summarywe set out a garden every year an its always a fight to keep the birds an deer from clipping our planets, use some kinda grease on all the surfaces that see contact an shafts an bolts an hopefully it will hold up. it may be changed at some point, cause all test thus far has been in door so its not seen a lot of run time at this point. at the moment i have a solar panel charging 2 18500 batterys in parallel an a step down convert going from the batterys to the motor. the motor is out of a power wheels so there might end up being a version that uses the gear box from the power wheels but for now this works. would be better off using a motor that isn't high rpm tho cause the motor out of the power wheels is 6v 14000 rpm an im running it at low voltage to keep the speed down but any lower than 1.8 volts an its not enough for the motor to start so i have it set at 2 an it will start own its own now but runs quite a bit faster than i would like but im still going to put it out an
Catégorie
Gadgets
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

2 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection