Slicer Discord
Garden Scarecrow – 3D-Druckmodell von Thingiverse Thingiverse

Garden Scarecrow

14 Downloads
15 Likes
0 Makes
Zum Modell
we set out a garden every year an its always a fight to keep the birds an deer from clipping our planets, use some kinda grease on all the surfaces that see contact an shafts an bolts an hopefully it will hold up. it may be changed at some point, cause all test thus far has been in door so its not seen a lot of run time at this point. at the moment i have a solar panel charging 2 18500 batterys in parallel an a step down convert going from the batterys to the motor. the motor is out of a power wheels so there might end up being a version that uses the gear box from the power wheels but for now this works. would be better off using a motor that isn't high rpm tho cause the motor out of the power wheels is 6v 14000 rpm an im running it at low voltage to keep the speed down but any lower than 1.8 volts an its not enough for the motor to start so i have it set at 2 an it will start own its own now but runs quite a bit faster than i would like but im still going to put it out an start test
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen