Thingiverse
Gauge
von Hockey_Sniper_16
15
Downloads
10
Likes
0
Makes
This is a gauge for outputting analog sensor readings using an SG90 servo. In my example Arduino sketch the gauge is used to display readings from a photo resistor but any analog sensor will work just as well. I put a lot of comments in the code but let me know if you need any help.
https://github.com/brendan234/gauge/blob/master/gauge.ino
I printed this in about 25 minutes using the extra fast setting on cura.
https://github.com/brendan234/gauge/blob/master/gauge.ino
I printed this in about 25 minutes using the extra fast setting on cura.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
