GBflash Endlosure

This is a Enclosure for the GBflash module, it is inspired by the design of ShikyC, but redesigned from the ground up. https://makerworld.com/de/models/1142519-gbflash-enclosure?from=search#profileId-1145065 There are two variants, one to use with M3 heatinserts and one with small holes, for the M3 bolts to screw directly into the plastic. You can either use M3x8mm or M3x10mm bolts. Due to the small font and details on the top it´s recommended to print it with a 0.2mm nozzle, but the button and the bottom can be printed with 0.4mm too. For the lights it´s recommended to use a small piece of transparent filament and push it inside, this can than be cut or sanded flush at the front. The fitment may vary, so this piece may need to be glued or melted in the back.