MakerWorld
Other Toys & Games
Go to Model
Gear Fidget Spinner
144
Downloads
16
Likes
89
Makes
This is my fidget spinner. It is 80mm diameter X 11mm thick If you are using an older version of Bambu Studio you need to set the correct Z-Y compensation These need to be as below to work correctly 0.15 for X-Y Hole Compensation on the outer ring gear-0.05 for X-Y Contour Compensation on all 6 of smaller gears This is printed in place and spins very freely
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
