Thingiverse
Gear Pump
87
Downloads
77
Likes
0
Makes
Gear Pump with mountable housing
-----------------------------------------------------------------------------------------------------------
Hey folks,
This is one of my first projects that I had to create while studying at the technical college.
The gear pump has a rotating and a driven axle (red), which are mounted in brass press bearings (white).
The housing cover and drive axle are sealed by two seals that I printed in the model with black flex filament.
After completion, I tested the printed pump, it is even pumped, however, far less than previously calculated.
This is probably due to the greater deviation than in a CNC machined, on the other hand also to leaks in the drive axle.
The pump is therefore rather intended as a model.
have fun cheers,
Steffen ;-)
-----------------------------------------------------------------------------------------------------------
Hey folks,
This is one of my first projects that I had to create while studying at the technical college.
The gear pump has a rotating and a driven axle (red), which are mounted in brass press bearings (white).
The housing cover and drive axle are sealed by two seals that I printed in the model with black flex filament.
After completion, I tested the printed pump, it is even pumped, however, far less than previously calculated.
This is probably due to the greater deviation than in a CNC machined, on the other hand also to leaks in the drive axle.
The pump is therefore rather intended as a model.
have fun cheers,
Steffen ;-)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
