Thingiverse
Geoffs Ender 3/5 Auto Level Bracket - Inductive Sensor
door geoff_cohen
15
Downloads
18
Likes
0
Makes
Similar to my earlier Ender 3 version - BUT - with an extra hole so it fits an Ender 5 as well as the Ender 3 - probably best printed in ABS as it's close to the hotend
===
My take on an Auto Level Bracket for an Ender 3/5 - unlike most other designs you don't need 2 spanners, as the top Nut has it's own hex nut Holder space - only 1 spanner to tighten the nut.
There's also a groove in the top to support the wire and prevent it getting caught on something.
Uses a standard 12mm Inductive Sensor (LJ12A3-4-Z/BX) , the bracket is designed so the nuts are (roughly) in the center of the threaded part.
===
My take on an Auto Level Bracket for an Ender 3/5 - unlike most other designs you don't need 2 spanners, as the top Nut has it's own hex nut Holder space - only 1 spanner to tighten the nut.
There's also a groove in the top to support the wire and prevent it getting caught on something.
Uses a standard 12mm Inductive Sensor (LJ12A3-4-Z/BX) , the bracket is designed so the nuts are (roughly) in the center of the threaded part.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
