Thingiverse
Goldtouch Split Keyboard Riser / Latch Replacement
von Buraku
0
Downloads
3
Likes
0
Makes
Goldtouch Split Keyboard Riser
if your latch gave up / broken you can consider using these
for now i just made it just the top, but i do considering rising the whole side. Maybe next time
if you need more cable slack you can unwind a little on the left side
if you need lube, you can just use 3d print maintenance grease rather than buy crytox
don't mind the notch i cut out manualy, i already fixed the model. but if it still interfering do let me know
if your latch gave up / broken you can consider using these
for now i just made it just the top, but i do considering rising the whole side. Maybe next time
if you need more cable slack you can unwind a little on the left side
if you need lube, you can just use 3d print maintenance grease rather than buy crytox
don't mind the notch i cut out manualy, i already fixed the model. but if it still interfering do let me know
Buraku veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
