Thingiverse
Goldtouch Split Keyboard Riser / Latch Replacement
door Buraku
0
Downloads
3
Likes
0
Makes
Goldtouch Split Keyboard Riser
if your latch gave up / broken you can consider using these
for now i just made it just the top, but i do considering rising the whole side. Maybe next time
if you need more cable slack you can unwind a little on the left side
if you need lube, you can just use 3d print maintenance grease rather than buy crytox
don't mind the notch i cut out manualy, i already fixed the model. but if it still interfering do let me know
if your latch gave up / broken you can consider using these
for now i just made it just the top, but i do considering rising the whole side. Maybe next time
if you need more cable slack you can unwind a little on the left side
if you need lube, you can just use 3d print maintenance grease rather than buy crytox
don't mind the notch i cut out manualy, i already fixed the model. but if it still interfering do let me know
Buraku publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
