Thingiverse
GoPro Float Handle
von johnrinker
27
Downloads
8
Likes
0
Makes
This GoPro Floaty handle with mount was made with Tinkercad, and it is based on the 'Bobber' floating handle design.
After printing, glue both handle halves together and then glue the GoPro mount to the flat surface.
After printing, glue both handle halves together and then glue the GoPro mount to the flat surface.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!