Thingiverse
GoUP!.gcode
por Martznip
0
Descargas
0
Likes
0
Makes
Just some simple Gcode to move the head up to access the bed for double Z printers that don't have commands for that (like with Marlin
goUP!.g>>>>move up 100mm
goUP!50.g>>>>move up 50mm
goUP!200.g>>>>Z home and move up 200mm
goUP!50HeatUP>>>>move up 50 and heat up to 200°C
Very easy to code for beginners using "control+F" and searching commands on this website: https://reprap.org/wiki/G-code
Of course you can modify it using notepad or others to adapt it to your needs !
For reducing time to achieve, there's no homing before (G28 Z).
Disclaimer: I am not responsible of any of the damages that can cause this gcode. Especially if you don't home the printer before, keep in mind that the printer can go too far and block the Z motor !
goUP!.g>>>>move up 100mm
goUP!50.g>>>>move up 50mm
goUP!200.g>>>>Z home and move up 200mm
goUP!50HeatUP>>>>move up 50 and heat up to 200°C
Very easy to code for beginners using "control+F" and searching commands on this website: https://reprap.org/wiki/G-code
Of course you can modify it using notepad or others to adapt it to your needs !
For reducing time to achieve, there's no homing before (G28 Z).
Disclaimer: I am not responsible of any of the damages that can cause this gcode. Especially if you don't home the printer before, keep in mind that the printer can go too far and block the Z motor !
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
