Thingiverse
GPU Support
von IDoesStuff
361
Downloads
333
Likes
5
Makes
I made this simple solution for my gpu that sagged very considerably. It can adjust from 87.5mm to 150mm (3.44" - 5.9"). It sits on the bottom of your case or the psu basement and extends up to a flat area on your gpu.
The first time you thread the nut onto the adjustable threads it will be a tight fit but once it's been adjusted fully then it becomes much easier to adjust.
The first time you thread the nut onto the adjustable threads it will be a tight fit but once it's been adjusted fully then it becomes much easier to adjust.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
