Gradient Pillars

The model is mostly OK to print with PLA, however I highly recommend using PETG or other material that has higher temperature endurance. LEDs get quite hot and might soften the PLA, especially white color at full brightness consumes the most power and generates heat. The semi transparent beams are printed with PETG. Don't try using perfectly clear materials like acrylic stick because the light should deflect from the impurities, so you need to use someone imperfect transparent materials. BambuLab translucent PETG was what I had at hand, so I used it. Esp8266 is flashed with WLED firmware. There are two touch buttons and eight WS2812 LEDs modules. All electronic components are from aliexpress. Here you can flash your esp8666 directly from browser with the latest WLED version.Important points when doing the electronic assembly:To get the LED PCBs fit into the slot, please trim the edges of PCB, it also helps to get rid of the splinters.Each LED PCB draws about 270mA, so in total they