Thingiverse
Gradient Tower
door prahjister
13
Downloads
14
Likes
1
Makes
Gradient tower to test out mixing filament. Very simple 100mm tall with notches every 10mm.
I made this to test out filament mixing to find desired combination.
I also included pre sliced gcode for the Geeetech A20M printer. It starts at 100:0 ratio to 0:100 at the top.
You can visually see the and find the perfect mix for your desired outcome.
I made this to test out filament mixing to find desired combination.
I also included pre sliced gcode for the Geeetech A20M printer. It starts at 100:0 ratio to 0:100 at the top.
You can visually see the and find the perfect mix for your desired outcome.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!