Slicer Discord
Green Computer Switch – 3D-Druckmodell von Thingiverse Thingiverse

Green Computer Switch

von bkubicek
9 Downloads
18 Likes
0 Makes
Zum Modell
Motivation
This thing goes between your power outlet and the extension cord to which all your computer gear is connected. The ecological dilemma is that you want to be able to switch on your computer conveniently by one switch, but most devices draw a standby power that can be between 1 and 10 W/device. This adds to your monthly bill.

Master/Slave extension cords or ones with switches are an alternative. However, after shutting down the PC is quite easy to forget to turn the switch, or there is still the standby current of the computer.

Function
Hence, this thing is a (partial) remedy. It basically disconnects all the devices from power. By pressing the big push-button, the computer/devices get connected to power. Most PCs have a BIOS setting "Automatic start on power loss". If this is enabled, the computer will boot up while the button is pressed. Of course also the 12V bus in the computer will be powered, and this voltage is connected to my device again, basically holding the
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Polycarbonate
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen