Slicer Discord
Grenade  – 3D-Druckmodell von MakerWorld MakerWorld
Characters

Grenade

5 Downloads
3 Likes
0 Makes
Zum Modell
It’s a exploding grenade that uses two springs and eight magnets there is a pin at the top that works as the priming mechanism and that removes the safety so that when the grenade hits something the magnets will disloge and the springs force will blow the sides apart For this build you will need a pen spring that goes on the top and makes the spoon shoot up a big spring to make the thing explode You will also need a standard key ring And a magnet set I found on Amazon for like $7 https://www.amazon.com/Magnets-Refrigerator-Neodymium-Whiteboard-Kitchen/dp/B0CCXZ1J6N/ref=sr_1_2_sspa?crid=2ZV95XMQXMA23&dib=eyJ2IjoiMSJ9.NuDLHwT7oXdhodjSpBBFAXR9o_oY7kwzQ-y-CpoOtwq8_PSlKWbmfDGvPwVl55SVb_Jm0uql8F0dz_dsWncxu5oUn6_wX34pQye_31U8bKE54vIBXZ9dyxz3l0zzgzufpN8m4b721cynGzrOwG8iO9OLWedZPG6bnJU73LmVD2qjT6XQU2SoPl-tTq8DojDHyHibC3lEDQ-p-Up8-FdNB2x02RSpXHI8_l7Ahuu_mKk.T_swhf4ZIIPT5aD0upak7sLfeTeByob44UeBfb0iFs8&dib_tag=se&keywords=tiny%2Bcircle%2Bmagnets&qid=1747246539&sprefix=Tiny%2Bcircle%2B%2Caps%2C149&
Kategorie
Characters
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen