Gridfinity SnapGridz v1 Collection

I found that grids, no matter the size, would slide away from each other and generally float around. So I had an idea to make life a little easier. CA glue sorta works for a little while but that is a mess. Also, I had no need to add a bazillion magnets to my grids and containers, at least at this time.My Solution, SnapGridz!Uses less filament than some grids and does not need metal fasteners. I can print out grids ahead of time, keep them in a box, and snap them together when needed. It's a good use for those almost empty spools of filament. A collection of various-size grids that can be snapped together with a bow-tie insert that keeps them together. I also came up with Cut-2-Fit spacers for the odd spaces from the edge of a grid to the side of a compartment that is narrower than a 1 x 1 Gridfinity grid. This keeps everything in place.Simply insert the Bow-Tie connector from the bottomPlace on hard flat surfaceand press down on the joint with the palm of your hand. TIP: if the connec