Thingiverse
H2_PrinterMods_Mount
von LeslieTroyer
2
Downloads
0
Likes
0
Makes
Mount to connect H2 (aka BX) extruder/hotend to my Ender 5 with Printer Mods Direct Drive Mount. It should also fit Printer Mods Ender 3 Direct Drive Mount and the Standard Ender 5 hot end Mount.
It was designed to have 4mm below the 3D Touch (BL Touch) but when assembled it only have 1.5mm. Haven't tested it.
Required Hardware.
2 - M3x6x5 brass thread insert
2 - M3x10 for adapter to mount - I used 12 cause that's what I had
2 - M3x6 for BL-Touch
2 - M3x8 for BX/H2
2 - M3x10 for wire cover
I used all black button head for above cause they look better and don't have to be recessed as deep.
I like brass thread inserts rather than captured nuts as nuts are too easy to cross thread.
It was designed to have 4mm below the 3D Touch (BL Touch) but when assembled it only have 1.5mm. Haven't tested it.
Required Hardware.
2 - M3x6x5 brass thread insert
2 - M3x10 for adapter to mount - I used 12 cause that's what I had
2 - M3x6 for BL-Touch
2 - M3x8 for BX/H2
2 - M3x10 for wire cover
I used all black button head for above cause they look better and don't have to be recessed as deep.
I like brass thread inserts rather than captured nuts as nuts are too easy to cross thread.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!