Thingiverse
Hacker Hotkey Case
von Kernelcon
8
Downloads
8
Likes
1
Makes
This is a casing for the Kernelcon 2021 Badge - Hacker Hotkey!
You can order a Hacker Hotkey at http://store.kernelcon.org
The casing is not necessary to use the device, but provides a nice clean finish.
Required two M3 screws to secure the hotkey board. 5mm-12mm.
You can order a Hacker Hotkey at http://store.kernelcon.org
The casing is not necessary to use the device, but provides a nice clean finish.
Required two M3 screws to secure the hotkey board. 5mm-12mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!