Slicer Discord
Halbach Array – 3D-Druckmodell von Thingiverse Thingiverse

Halbach Array

1 Downloads
0 Likes
0 Makes
Zum Modell
This is a simple holder for a series of magnets in order to make a Halbach array. Halbach arrays negate the magnetic field on one side and enhance it on the other. I used simple little 15x6.5x3 rare earth bar magnets from amazon. I glued two magnets together at a time to make a square and then inserted them into the holder. You rotate the square magnet with N pointing at 12:00 - 3:00 - 6:00 - 9:00 until the holder is full. Then glue them all in place.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen